Water pump running but not pumping water? Common causes
By the QwikSkill team ยท Updated 20 November 2026
Your pumping machine hums, but the overhead tank stays empty. This is one of the most common water problems in Nigerian homes, and the cause is often simple.
Common causes
- Lost prime: air has got into the pump and pipe, so it spins without pulling water. This often happens after the well or borehole level dropped, or after a long power cut.
- Low water at the source: the well, borehole or underground tank is low, so the pump is sucking air.
- A blocked or stuck foot valve: the valve at the bottom of the suction pipe is clogged with dirt or stuck, so water drains back down.
- A leak on the suction side: a cracked pipe or loose joint between the source and the pump lets air in.
- A worn impeller or seal: the part inside that moves the water is worn out, often in older pumps.
- The wrong pump for the job: the tank is too high or too far for the pump's power.
What you can safely check
- Switch the pump off at the socket first.
- Check the water level at the source: is there enough water?
- Look along the pipes from the source to the pump for wet spots, cracks or loose joints.
- If you know how, prime the pump: fill it with water through the priming plug, close it, and switch on. If water comes up and then stops again, there is probably a leak or a faulty foot valve.
- Don't leave a pump running dry for long: it can burn out the motor.
When to call a plumber
Call a plumber if priming doesn't help, if you see a leak you can't fix, if the pump is noisy or hot, or if water comes up only weakly. They can test the foot valve, find air leaks, check the impeller and tell you whether the pump is right for your tank height.
Questions
Why does my pump work in the morning but not later in the day?
Often the well or borehole level drops as the day goes on, so the pump starts sucking air. A plumber can check the water level and how deep the suction pipe goes.
Can running a pump without water damage it?
Yes. Running dry heats the pump and can damage the seal and motor. Switch it off if no water is coming.